Whelping box V2 coated

Whelping box V2 coated

Whelping box V2 coated.

The ideal place to give birth to the puppies!

The professional litter box made of robust, scratch-resistant Finnish plywood.

With the whelping box you give your dogs a safe place in the most important part of their lives, plus a clean, warm and sustainable environment for the young puppies. Optionally, a puppy protection and a lid are available for each whelping box V2.

The sturdy whelping box is carefully designed and made of high quality materials, for high functionality and durability! Breeders can therefore also raise several litters in them.

The whelping box can be assembled without screws and can be dismantled in a few parts, only a hammer and the supplied mounting wood are needed. This means that the whelping box can be stored in a space-saving manner when not in use and quickly set up again when the next litter has to be placed.

Equipment of the litter box:

• Handmade from Finnish coated plywood, which is known for its robust and scratch-resistant surface
• 12 mm thickness of sides and bottom
• Inner floor and outer sides of non-slip, rough, scratch and bite-resistant material
• Inner sides are made of smooth, easy to clean, scratch and bite resistant material
• Corners and edges bite-resistant protected with high-quality anodized aluminum
• All metal elements used are made of aluminum or stainless steel
• rubber feet for a firm stand; extra rubber foot in the middle under the entrance to prevent extra strain when getting in and out
• entrance consisting of three elements; these can be individually removed upwards via the rails. So access can be increased depending on the age of the puppies to prevent them from leaving the litter box.
• Supplied as a kit with instructions and mounting wood; ordered together with the puppy guard also includes 8 screws and hexagon wrench for mounting.
• Construction by simply plugging it together and then fixing it from the outside with a hammer (use assembly wood)
• Can be dismantled again without screws in 4 steps: put assembly wood from the inside in the corners (each on the front and back wall) and use the hammer to loosen the connection of the parts.

Also available as a version with heating plate:

• electronically controlled heating plate, suitable for the lying surface of the throwing box
• scratch and waterproof glued plywood panel with integrated heating cables and temperature sensors, total thickness approx. 21 mm
• splash-proof control unit with 20 volt transformer – operation with harmless low voltage
• Cable between heating plate and control unit, approx. 3 m long
• Cable between control unit and power connection, approx. 3 m long, with mains plug for 230 V socket
• Accurate temperature control (from approx. 15°C to approx. 32°C).
• Power consumption approx. 150 to 180 watts per m² in the heating phase
• Electronic control of the set bottom temperature - constant temperature without exceeding or falling below, heating stop when temperature is reached

In addition to the sizes mentioned, custom products (including the heating plate) are possible for your special needs. Then please contact us!

Available dimensions:

• 45 x 66 x H 30 cm
• 55 x 75 x H 40 cm
• 68 x 107 x H 45 cm
• 80 x 110 x H 50 cm
• 88 x 124 x H 55 cm
• 120 x 140 x H 60 cm

Do not forget:
Purchase puppy protection and lid at the same time!